Daikin RSEYP16KJY1, Инструкции по проектированию, установке и тестированию

Страница: 68 / 204

Si33-107 Test Operation
General Information 67
**
3 := , 9A$ ():
7(+:>,
The factory settings are:
Individual (C/H SELECT), OFF (L.N.O.P.), ON (SEQ. START)
You can change the cool/heat selection permission, low noise and
sequential start settings by pushing the SET switch.
To skip settings you don't want to change, push the RETURN switch
and go to the next setting.
Set cool/heat
selection to IND.
Change low noise operation to "ON".
External control adaptor for outdoor unit is required
if low noise operation is set to "ON".
Change sequential start to "OFF".
Setting complete
GROUP MASTER (cool/heat selection),
ON (low noise), OFF (sequential start)
MODE TEST L.N.O.P.
SEQ.
IND MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
SET
MODE TEST L.N.O.P.
SEQ.
IND MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
SET
MODE TEST L.N.O.P.
SEQ.
IND MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
MODE TEST L.N.O.P.
SEQ.
IND MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
SET
SET
MODE TEST L.N.O.P.
SEQ.
IND MASTER SLAVE START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
MODE TEST L.N.O.P.
SEQ.
IND MASTER SLAVE START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
SET
MODE TEST L.N.O.P.
SEQ.
IND MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
C/H
SELECT
SS1
IN/D
UNIT
OUT/D
UNIT
Cool/heat selection setting
(SS1)
(Factory set)
Do not set
RETURN
RETURN
RETURN
Monitor mode
MODE
Setting mode 2
MODE
Push and hold for 5 sec.
C/H SELECT
(VF133)