8
To set the batteries
1.
Press
with a finger and slide the cover to take it off.
2.
Set 2 dry batteries AAA.LR03 (alkaline).
3.
Set the cover as before.
• Characters on the display will blink. Set the present time.
Page 9
4.
Change the temperature display. See SET UP.
Page 18
To fix the remote controller holder on the wall
1.
Choose a place from where the signals reach the unit.
2.
Fix the holder to a wall, a pillar, etc. with the screws supplied
with the holder.
3.
Hook the holes on back of the remote controller to the
protruding tabs on the remote controller holder.
Attach the Titanium apatite photocatalytic air-purifying filter,
deodorizing filter for streamer
Page 25
Turn on the power breaker
• After the power is turned on, the louvers of the indoor unit open and close once to set the
reference position.
CAUTION
• During operation (i.e. when the panel is open or being opened or closed), do not touch the panel with your
hands.
2
3
1
Position + and
– correctly!
Remote
controller
holder
Preparation before Operation
ATTENTION
• Wrap the terminals with tape to insulate them before discarding batteries. Mixing with other metals or batteries may cause heat, explosion or fire.
NOTE
Notes on batteries
• When replacing the batteries, use batteries of the same type, and replace both batteries at the same time.
• When the system is not used for a long time, take the batteries out.
• The batteries will last for approximately 1 year. If the remote controller display begins to fade and the degradation of reception performance occurs
within a year, however, replace both batteries with new size AAA.LR03 (alkaline).
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
Notes on remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with a soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. Consult the
service shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.
Celsius/Fahrenheit display change function of remote controller
• The set temperature may increase when the display is changed to Celsius from Fahrenheit, because a fraction of 0.5°C is rounded up.
Example: A set temperature of 65°F (equivalent to 18.5°C) will be converted into 19°C.
When the display is changed to Fahrenheit again, the set temperature will be converted into 66°F (equivalent to 19°C) instead of the
original set temperature (65°F) but a set temperature of 66°F (equivalent to 19°C) will be converted into 19°C with no temperature change.
• A reception sound will go off for the transmission of set temperature to the indoor unit at the time of setting the Celsius/Fahrenheit display change function.
01_EN_3P226009-1A.indd 8
10/29/2012 2:11:51 PM
