Daikin MicroTech III, Руководство по устранению неисправностей

Страница: 25 / 40

Download and Configuration - LonWorks
www.DaikinApplied.com 25 OM 1085-6 • MICROTECH III CONTROLLER
Configuring the LonWorks
Communication Network
The following section describes how to create a LonWorks
communication network drawing and import the WSHP Device
Template into the network using CT.
1. Open the Echelon IzoT Commissioning Tool. The Design
Manager screen appears ( Figure 50) .
Figure 50: IzoT Commissioning Tool Design Manager
2. Either create a new network or select an existing
network.
a. To select an existing network:
i. Select the network from the Drawing directory
drop-down menu.
ii. Click on Open Network.
iii. Proceed to the Commissioning the LonWorks
Communication Module section.
b. To create a new network:
i. Enter a name in the Network name field and
then click Create Network.
3. Select the Network Interface Name ( Figure 51) as
determined from step 5 of the Installation and Setup
section ( Figure 48) .
Figure 51: LonWorks Interface Name
4. Click Next.
5. Verify the Management Mode is OnNet and click Finish
( Figure 52) .
Figure 52: Management Mode
6. A screen similar to Figure 53 appears.
7. Drag the Device icon (shown on the left-hand side of the
image in Figure 53 ) to the center of the screen.
Figure 53: LNS Network Interface Screen