Daikin MicroTech II, Руководство по эксплуатации и обслуживанию

Страница: 5 / 44

www.DaikinApplied.com 5 OM 752-4
I
ntroduCtIon
Table 4: Software program literature
Description Manual #
Air Source Heat Pump with Electric Heat (Software Model 00) OM 748
Water Source Heat Pump with Electric Heat (Software Model 02)
Water Source Heat Pump without Electric Heat (Software Model 03)
OM 749
DX Cooling with Electric Heat (Software Model 04) OM 750
DX Cooling Only (Software Model 05) OM 751
Electric Heat Only (Software Model 06) OM 752
DX Cooling with Hydronic Heat - Valve Control (Software Model 07)
DX Cooling with Hydronic Heat - F&BP Damper Control (Software Model 08)
OM 753
2-Pipe Hydronic Heat Only -Valve Control (Software Model 09)
2-Pipe Hydronic Heat Only - F&BP Damper Control (Software Model 10)
OM 754
2-Pipe Chilled Water Cooling and Hot Water Heat - Valve Control (Software Model 11)
2-Pipe Chilled Water Cooling and Hot Water Heat - F&BP Damper Control (Software Model 12)
OM 755
4-Pipe Chilled Water Cooling and Hydronic Heat - Valve Control (Software Model 13)
4-Pipe Chilled Water Cooling and Hydronic Heat - F&BP Damper Control (Software Model 14)
OM 756
2-Pipe Chilled Water Cooling Only - Valve Control (Software Model 15)
2-Pipe Chilled Water Cooling Only - F&BP Damper Control (Software Model 16)
OM 757
2-Pipe Chilled Water Cooling with Electric Heat - Valve Control (Software Model 17)
2-Pipe Chilled Water Cooling with Electric Heat - F&BP Damper Control (Software Model 18)
OM 758
NOTICE
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with this instruction manual, may cause interference to radio communications. It has
been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable protection against detrimental interference
when the equipment is operated in a commercial environment. Operation of this equipment in a resi-
dential area is likely to cause detrimental interference in which case users are required to correct the
interference at their own expense. Daikin disclaims any liability resulting from any interference or for the
correction thereof.
WARNING
Electric shock hazard. Can cause per onal injury or equipment damage. This equipment must be prop-
erly grounded. Connections and service to the MicroTech II control panel must be performed only b
personnel that are knowledgeable in the operation of the equipment being controlled.
CAUTION
Extreme temperature can damage system components. The MicroTech II controller is designed to oper-
ate in ambient temperatures from -20°F to 125°F. It can be stored in ambient temperatures from -40°F
to 140°F. It is designed to be stored and operated in relative humidity up to 95% (non-condensing).
CAUTION
Static sensitive components. A static discharge while handling electronic circuit boards can damage
components. Discharge any static electrical charge by touching the bare metal inside the main control
panel before performing any service work. Never unplug any cables, circuit board terminal blocks, relay
modules, or power plugs while power is applied to the panel.