Daikin Intelligent Touch Manager DCM601A71, Руководство по установке

Страница: 38 / 44

38 Installation Manual 3P291714-2B
DCM601A71 intelligent Touch Manager
English
4.7.3 Setting address with navigation remote controller
The operation procedure of the navigation remote controller is as follows.
NOTE
You cannot perform the following procedure when the display backlight is off. In this
case, press any key to turn on the backlight before starting the procedure.
1. Press and hold the Cancel button for 4 seconds or more.
The “Service setting” menu is displayed.
<Step 1>
Cool
Room
Thu
82
78
F
Set to
31
P
5
F
2. Using the Up/Down buttons, select “Group Address” and press the Menu/OK button.
The “Group Address” menu is displayed.
<Step 2>
Group Address
Indoor unit AirNet Address
Forced Fan ON
Setting
Ser vice Settings
Error Histor y
Outdoor Unit Status
Indoor Unit Status
2/3
NOTE
The “Group Address” menu is not displayed when the intelligent Touch Manager is not
powered on. Power on the intelligent Touch Manager and wait for a while before trying
to operate the remote controller. The “Group Address” menu is not displayed also when
the intelligent Touch Manager is not communicating with the indoor units normally.
Check that the cables are connected correctly.
3. Using the Up/Down buttons, select “Group Address (Group)” and press the Menu/OK button.
The current address setting is displayed.
<Step 3>
Group Address (Unit)
Setting
Group Address
Group Address (Group)
4. Press the Menu/OK button to release the current address setting.
The mode indication changes from “Set” to “Release”. You are now ready to change the
DIII-NET address.
<Step 4>
Gr Addr. Set
1-00
Release
Group Address (Group)