IM 837-2 • MICROTECH II CHILLER UNIT CONTROLLER 16 www.DaikinApplied.com
Network Configuration
Figure 13: Verify Changes and Reboot System
Clock Setup
Use the Clock Setup page to change settings as required for
your network (
Figure 14
).
Table 5
defines the communication
module’s clock parameters. The clock is non-volatile, so if
the clock is used, the Date and Time must be reset every
time power is cycled to the unit controller or when the
communication module is rebooted.
Question marks (‘??’) in any field represent an invalid value.
If question marks appear, refresh the page, enter a valid date
and time, and press the Set Clock button to reset the clock
parameters.
Figure 14: Clock Setup Tab
Table 5: Clock Parameters
Field
Parameter
Value (Range)/
Description
Default Value
Local Date/Time
Year
Current Year
4-digit year
Month
Current Month (1-12)
Day
Current Day (0-X, where
X is the number of days in
the month)
Hour
Current Hour (0-23)
Minute
Current Minute (0-59)
Second
Current Second (0-59)
System Configuration
The communication module System Configuration information
appears under the General, Network, Communications, Users,
and Firmware tabs. The following section describes each tab.
Change parameters as required for your network.
General Tab
This page is used only to view system information. The
information includes used/free disk space, factory bootswitch
(default) parameters, network configuration, and environment
variables.
Figure 15:
System Configuration - General
Tab
Network Tab
Use the network tab to change the IP Address and IP Subnet
Mask along with other parameters. See
Figure 16
and
Table 6
for details.
Figure 16:
System Configuration - Network
Tab
Содержание IM 837-2
Страница 21: ......
