Daikin GYEQ20AN, Руководство по обслуживанию

Страница: 132 / 245

Troubleshooting the Outdoor Unit SiAUY361411EA
121 Troubleshooting
1.4 STOP Mode
• When the slide switch is switched to STOP, the unit enters STOP mode.
• To exit from STOP mode, set SW1 to the RUN position so that the total operated hours are
displayed.
Note that the outdoor unit starts operation if the remote controller is in the operation mode
when SW1 is shifted to RUN.
• STOP mode has five levels from 1 to 5. Use the and buttons to shift
between these levels.
• You can switch the channels using the and buttons.
Table 4.10/ List of STOP mode menu items
∗
During STOP mode, the display is automatically returned to STOP twenty seconds after the
termination of operation.
1.4.1 Alarm Display
Enter STOP mode, make sure that the display [1] (CH1: alarm display) is selected in Level 1,
and press
. The alarm code is displayed.
To clear the alarm condition, hold down for 3 seconds.
Level 1 Level 2 Level 3 Level 4 Level 5
CH i
te
m
1. Alarm display Alarm display Alarm reset
2. Actuator check With actuator check Actuator check action
3. Configure items 01. ON/OFF unit
(memory switch)
Each item ON/OFF
display Item data
update
02. Not used
4. Alarm/warning
history
Alarms/warnings Among alarm/warning
history Alternate display of
alarm content
SW1
BACK
NEXT
UP
DOWN
NEXT
ENTER