Removal of Fan Rotor / Fan Motor
Si06-760
12
Removal Procedure
2. Detach the fan motor.
<Attention in the fan motor
installation>
Before you tighten screws, be
sure that the rubber vibration
isolators (front, back) of the fan
motor firmly fit into the both
holes of the installation board
and fan motor cover when you
install a fan motor.
1
Remove the 2 screws
on the left side and
remove the fan harness
cover.
2
(1) Disconnect the relay
harness.
(2) Pinch the both sides
of the spring.
(3) Pull out the
connector from the
plate.
3
Remove the 2 screws
on the right side and
remove the fan motor
stand.
The left 2 screws, which
tighten the fan harness
cover, have been
already removed at
procedure 1.
Step
Procedure
Points
(R18535)
Screws
Fan
harness
cover
(R4647)
(3)
(1)
(2)
(2)
(R18536)
Fan motor stand
Screws
