21
■
To use ON TIMER
operation
• Check that the clock is correct. If not, set
the clock to the present time. (page 8.)
1. Press “ON TIMER button”.
“
” is displayed.
“
” blinks.
2. Press “SELECT button” until
the time setting reaches the
point you like.
• Each pressing of either button
increases or decreases the time setting
by 10 minutes. Holding down either
button changes the setting rapidly.
3. Press “ON TIMER button”
again.
• The TIMER lamp lights up.
■
To cancel ON TIMER
operation
4. Press “CANCEL button”.
• The TIMER lamp goes off.
■
To combine ON TIMER and OFF TIMER
• A sample setting for combining the two timers is shown below.
ATTENTION
■
In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
1, 3
4
2
(Example)
Present time: 11:00 p.m.
(The unit operating)
OFF TIMER at 0:00 a.m.
ON TIMER at 7:00 a.m.
Combined
Display
01_EN_3P266961-1.fm Page 21 Tuesday, June 8, 2010 2:36 PM