Daikin FTXS-L Series, Инженерные данные

Страница: 126 / 206

EDUS091128 Operation Manual
Split Type Air Conditioners FTXS-L / FDXS-L Series 125
Preparation before Operation
„
To set the batteries
2
3
1
Position and
correctly! +
–
Slide the front cover to take it off.
1.
Set two dry batteries AAA.LR03 (alkaline).
2.
Set the front cover as before.
3.
„
To fi x the remote controller holder on the wall
Remote
controller holder
Remote controller
Screws
Choose a place from where the signals reach
1.
the unit.
Fix the holder to a wall, a pillar, etc. with the
2.
screws supplied with the holder.
Place the remote controller in the remote
3.
controller holder.
„
Celsius/Fahrenheit display switch
The Celsius or Fahrenheit display is selectable with the following buttons. •
Press and simultaneously for
5 seconds.
The temperature will be displayed in Fahrenheit if it is presently displayed in Celsius, •
and vice versa.
NOTE
Notes on batteries
„
When replacing the batteries, use batteries of the same type, and replace both batteries at the same time. •
When the system is not used for a long time, take the batteries out. •
The batteries will last for approximately 1 year. If the remote controller display begins to fade and the degradation of reception performance •
occurs within a year, however, replace both batteries with new, size AAA.LR03 (alkaline).
The attached batteries are provided for the initial use of the system.
•
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
Notes on remote controller
„
Never expose the remote controller to direct sunlight. •
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with a soft cloth. •
Signal communication may be disabled if an electronic-starter-type fl uorescent lamp (such as inverter-type lamps) is in the room. Consult the •
shop if that is the case.
If the remote controller signals happen to operate another appliance, move that appliance somewhere else, or consult the service shop.
•
Celsius/Fahrenheit display change function of remote controller
„
The set temperature may increase when the display is changed to Celsius from Fahrenheit, because a fraction of 0.5°C is rounded up. •
Example: A set temperature of 65°F (equivalent to 18.5°C) will be converted into 19°C. •
When the display is changed to Fahrenheit again, the set temperature will be converted into 66°F (equivalent to 19°C) instead of the
original set temperature (65°F) but a set temperature of 66°F (equivalent to 19°C) will be converted into 19°C with no temperature change.
A reception sound will go off for the transmission of set temperature to the indoor unit at the time of setting the Celsius/Fahrenheit display change function. •