■
English
8
4.
Wiring
Refer to the installation manual for the outdoor unit also.
WARNING
• Do not use tapped wires, extension cords, or starburst connections, as they may cause overheating, electric shock, or fire.
• Do not use locally purchased electrical parts inside the product. (Do not branch the power for the drain pump, etc., from the
terminal block.) Doing so may cause electric shock or fire.
• Do not connect the power wire to the indoor unit. Doing so may cause electric shock or fire.
CAUTION
Recommend stranded cable for interunit wiring. Local code always supersedes recommendation.
• For stranded wires, make sure to use the round crimp-style terminal for connection to the power supply terminal block. Place
the round crimp-style terminals on the wires up to the covered part and secure in place.
• If solid core wire must be used, be sure to curl the end of the lead. Improper work
may cause heat and fire.
, install as described in the installation manual supplied with the multi outdoor
unit.
1) Remove the upper front panel, then remove the service lid.
(Refer to the opening method on page 4.)
2) Lift up the unit and place it on the
mounting plate
hooks.
3) Remove the front grille.
(Refer to the removal method on page 11.)
4) Remove the conduit mounting plate and then secure the
conduit to the conduit mounting plate with the lock nut,
as shown in the illustration.
5) Strip wire ends (3/4 inch (20mm)).
6) Match wire colors with terminal numbers on the indoor
and outdoor unit’s terminal blocks and firmly secure the
wires in the corresponding terminals with the screws.
7) Connect the ground wire to the corresponding terminals.
8) Pull the wires lightly to make sure they are securely
connected.
Screw
Screw
Flat washer
Flat washer
Good
Wrong
Round
crimp-style
terminal
Round crimp-style
terminal
A
Screw
Round
crimp-style
terminal
Flat washer
Arrow view
A
Stranded wire
Round
crimp-style
terminal
Good
Wrong
With a multi indoor unit
A Mounting plate
Hang indoor unit on the hooks
of mounting plate.
A
Screw
Lock nut
Conduit pipe
Conduit
Conduit
mounting plate
Electrical wiring box
1 2
3
Strip wire ends
(3/4 inch
(20mm)).
3/4 inch
(20mm)
Use the specified wire type.
Shape wires so that the
service lid will fit securely.
Terminal block
Electrical wiring box
Wire retainer
1
2
3
1 2 3
L
1
L
2
Firmly fix the wires with
the terminal screws.
Outdoor
unit
Indoor
unit
Firmly fix the wires with
the terminal screws.
Using AWG14 stranded and insulated wire for
connections between indoor and outdoor units
is recommended. Local codes always
supersede recommendations.
01_EN_3P674703-1.fm 8 ページ 2022年3月29日 火曜日 午後3時40分