![background image](http://html1.mh-extra.com/html/daikin/ftxg25evmaw/ftxg25evmaw_operation-manual_4702108009.webp)
8
Preparation Before Operation
■
To operate the remote controller
• To use the remote controller, aim the transmitter at the
indoor unit. If there is anything to block signals
between the unit and the remote controller, such as a
curtain, the unit will not operate.
• Do not drop the remote controller. Do not get it wet.
• The maximum distance for communication is about 7m.
■
To fix the remote controller holder on the wall
1. Choose a place from where the signals
reach the unit.
2. Fix the holder to a wall, a pillar, or similar
location with the screws procured locally.
3. Place the remote controller in the
remote controller holder.
■
Turn on the power breaker
• Turning on the power breaker will cause the panel and
flap to open once and then close again.
(This is a normal procedure.)
CAUTION
ATTENTION
• During operation (i.e. when the panel is open or being opened or closed), do not touch the
panel with your hands.
■
■
■
■
About remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such
as inverter-type lamps) is in the room. Consult the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance
to somewhere else, or consult the shop.
Receiver
Remote controller
holder
Set.
●
To remove, pull it upwards.
Panel
Flap
01_EN_3P166462-1.fm Page 8 Tuesday, September 20, 2005 5:08 PM
Содержание FTXG25EVMAW
Страница 27: ...26 MEMO 01_EN_3P166462 1 fm Page 26 Tuesday September 20 2005 5 08 PM...
Страница 28: ...27 MEMO 01_EN_3P166462 1 fm Page 27 Tuesday September 20 2005 5 08 PM...
Страница 29: ...28 MEMO 01_EN_3P166462 1 fm Page 28 Tuesday September 20 2005 5 08 PM...
Страница 30: ...0509 HT 3P166462 1 M05B042 00_CV_3P166462 1 fm Page 2 Monday October 3 2005 7 50 PM...