Daikin FT50GAVEA, Руководство по эксплуатации

Страница: 9 / 20

8
Preparation Before Operation
■ ■ ■ ■ ■
Setting the air purifying filters
Indoor unit
NOTE
Pull out the air filters.
●
Push upwards the
tab at the center of
each air filter, then
pull it down.
2
Open the front grille.
●
Hold the grille by the tabs on the two sides
and lift it until it stops with a click.
(about 60°)
1
Set the air purifying filters.
●
Attach an air purifying filter to each air filter.
(See page 13 “Care and cleaning”)
Set the air filters in their original
positions and close the front grille.
●
Operation without air filters may result in
troubles as dust will accumulate inside the
indoor unit.
3
4
Please note
●
The air conditioner always consumes 7 watts of
electricity even while it is not operating.
●
If you are not going to use the air conditioner for a
long period, for example in spring or autumn, turn
the breaker OFF.
●
Use the air conditioner in the following conditions.
Mode
COOL
HEAT
DRY
Operating conditions
Outdoor temperature : 19 to 46 °C
Indoor temperature
: 18 to 32 °C
Indoor humidity : 80% max.
Outdoor temperature : –10 to 21 °C
Indoor temperature
: 27 °C max.
Outdoor temperature : 19 to 46 °C
Indoor temperature
: 18 to 32 °C
Indoor humidity : 80% max.
If operation is continued out of this range
•
A safety device may work to stop the operation.
(In multi system, it may work to stop
the operation of the outdoor unit only.)
•
Condensation may occur on the indoor unit and drip.
•
A safety device may work to stop the operation.
•
A safety device may work to stop the operation.
•
Condensation may occur on the indoor unit and drip.
Tips for saving energy
●
Be careful not to cool the room too much.
Keeping the temperature setting at a
moderate level helps save energy.
Recommended temperature setting
For cooling: 26°C – 28°C
For heating: 20°C – 24°C
●
Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors
increases the cooling effect.
●
Clogged air filters cause inefficient
operation and waste energy. Clean them
once in about every two weeks.
●
Holding down ( ) or ( ) button
rapidly increases or decreases the time display.
■ ■
■ ■
■
Setting the clock
Press .
Press
TIMER
to set the clock to the present
time.
■ ■
■ ■ ■
Turn the breaker ON
●
Turning ON the breaker opens the flap, then
closes it again. (This is a normal procedure.)
1
AM
is displayed.
2
AM
Display
blinks.
3
Press .
PM
Display
blinks.
(Now the clock is set.)
PM
Display