Daikin FHQ100BUV1B x 2, Руководство по обслуживанию

Страница: 280 / 314

SiBE28-804 RZQ71C7, RZQS71·100C7V1B
Removal Procedure 269
1.2 Removal of Propeller Fan and Fan Motor
Procedure Warning Be sure to commence the disassembling work after 10 minutes or
more elapsed from all power supplies have been turned off.
Step
Procedure Points
Remove the front panel 2,
following the procedure
indicated at "Removal of
Outside Panels and
Related Parts".
1. Remove the propeller fan
1
Remove the four
screws that fix the
discharge grille.
Remove from four
hooks at upper and
lower side and then
remove the discharge
grille.
2
Remove the fan setting
nut that fixes the
propeller fan.
3
* Remove the top
panel, following the
procedure indicated
at "Removal of
Outside Panels and
Related Parts".
2. Remove the fan motor In case of removing the
connector, do not pull the
lead wire. Hold the
connector part and push the
hook.
Precaution for the motor
installation
Be sure to fix the lead wire of
the motor. Otherwise the
lead wire might be entangled
with the motor and causes
failure.
1 Remove the connector
for the fan motor from
the printed wiring board
(PWB). (Refer to *1)
2 Remove the three
clamps which fix the
lead wire. (Three hooks
of partition plate)
3 Remove the three
screws of the front
panel and then pull lead
wire frontward.
4 Pull out the fan motor,
after removing the four
fixing bolts.
Propeller fan
Fan setting nut
Hooks
Hooks
Discharge grille
Connector for fan motor (X106A)
Four bolts
Clamp
Lead wire Propeller fan