Daikin FDA200AXVEB, Инструкция по установке и эксплуатации

Страница: 13 / 20

13 Maintenance and service
Installation and operation manual
13
250AXVEB
Split system air conditioners
3P580564-1 – 2019.04
DANGER: RISK OF ELECTROCUTION
To clean the air conditioner or air filter, be sure to stop
operation and turn all power supplies off. Otherwise, an
electric shock and injury may result.
WARNING
To prevent electric shocks or fire:
▪ Do NOT rinse the unit.
▪ Do NOT operate the unit with wet hands.
▪ Do NOT place any objects containing water on the unit.
CAUTION
After a long use, check the unit stand and fitting for
damage. If damaged, the unit may fall and result in injury.
CAUTION
Do NOT touch the heat exchanger fins. These fins are
sharp and could result in cutting injuries.
WARNING
Be careful with ladders when working in high places.
13.2 Cleaning the air filter and air outlet
13.2.1 To clean the air outlet
WARNING
Do NOT let the indoor unit get wet. Possible
consequence: Electric shock or fire.
NOTICE
▪ Do NOT use gasoline, benzene, thinner polishing
powder or liquid insecticide. Possible consequence:
Discoloration and deformation.
▪ Do NOT use water or air of 50°C or higher. Possible
consequence: Discoloration and deformation.
Clean with a soft cloth. If it is difficult to remove stains, use water or
a neutral detergent.
13.2.2 To clean the air filter
When to clean the air filter :
▪ Rule of thumb: Clean every 6 months. If the air in the room is
extremely contaminated, increase the cleaning frequency.
▪ Depending on the settings, the user interface can display the
"Time to clean filter" notification. Clean the air filter when the
notification is displayed.
▪ If the dirt becomes impossible to clean, change the air filter.
How to clean the air filter :
1 Remove the screws on the filter cover using screwdriver.
2 Slowly pull out the air filter (composed of 3 equal parts).
3 Clean the air filter. Use a vacuum cleaner or wash with water. If
the air filter is very dirty, use a soft brush and neutral detergent.
4 Dry the air filter in the shadow.
5 Re-attach the air filter. Partially re-insert the first part of the air
filter, align the middle part of the air filter with first part and push
the 2 clips in place to lock the filter parts together. Repeat the
procedure for the last part of the filter.
6 Place the filter cover back. Fix the filter cover with screws.
7 Turn ON the power.
8 To remove warning screens, see the reference guide of the
user interface.
13.3 Maintenance before a long stop
period
E.g., at the end of the season.
▪ Let the indoor units run in fan only operation for about half a day in
order to dry the interior of the units.
▪ Turn off the power. The user interface display disappears. When
the main power is turned on, the air conditioner will use some
power, even if it is not operating.
▪ Clean the air filter and the casing of the indoor unit (see
"13.2 Cleaning the air filter and air outlet" on page 13 ). Make
sure to install cleaned air filters back in the same position.
▪ Remove the batteries from the user interface (if applicable).
13.4 Maintenance after a long stop
period
E.g., at the beginning of the season.
▪ Check and remove everything that might be blocking inlet and
outlet vents of indoor units and outdoor units.
▪ Check if the earth is connected properly.