Daikin FCAHG71HVEB, Инструкция по установке и эксплуатации

Страница: 16 / 20

13 Maintenance and service
Installation and operation manual
16
FCAHG71~140HVEB
Split system air conditioners
4P535639-1B – 2019.01
4 Dry the air filter in the shadow.
5 Reattach the air filter and close the suction grille.
6 Turn ON the power.
7 Press the FILTER SIGN RESET button.
Result: The TIME TO CLEAN AIR FILTER notification
disappears from the user interface.
13.2.2 To clean the suction grille
NOTICE
Do NOT use water of 50°C or higher. Possible
consequence: Discoloration and deformation.
1 Open the suction grille.
Standard panel:
1
Design panel:
1
1
2
2
2 Remove the suction grille.
Standard panel:
45°
1
2
Design panel:
1
2
3 Remove the air filter.
1
2
3
4 Clean the suction grille. Wash with a soft bristle brush, and
water or neutral detergent. If the suction grille is very dirty, use
a typical kitchen cleaner, leave it on for 10 min, then wash it
with water.
5 Reattach the air filter and suction grille, and close the suction
grille.
13.2.3 To clean the air outlet and outside panels
WARNING
Do NOT let the indoor unit get wet. Possible
consequence: Electric shock or fire.
NOTICE
▪ Do NOT use gasoline, benzene, thinner polishing
powder or liquid insecticide. Possible consequence:
Discoloration and deformation.
▪ Do NOT use water or air of 50°C or higher. Possible
consequence: Discoloration and deformation.
▪ Do NOT scrub firmly when washing the blade with
water. Possible consequence: The surface sealing
peels off.
Clean with a soft cloth. If it is difficult to remove stains, use water or
neutral detergent.
13.3 Maintenance after a long stop
period
E.g., at the beginning of the season.
▪ Check and remove everything that might be blocking inlet and
outlet vents of indoor units and outdoor units.
▪ Clean air filters and casings of indoor units (see "13.2.1 To clean
the air filter" on page 15 and "13.2.3 To clean the air outlet and
outside panels" on page 16 ).
▪ Turn on the power at least 6 hours before operating the unit in
order to ensure smoother operation. As soon as the power is
turned on, the user interface display appears.
13.4 Maintenance before a long stop
period
E.g., at the end of the season.
▪ Let the indoor units run in fan only operation for about half a day in
order to dry the interior of the units. Refer to "12.2.2 About
cooling, heating, fan only, and automatic operation" on page 13
for details on fan only operation.
▪ Turn off the power. The user interface display disappears.
▪ Clean air filters and casings of indoor units (see "13.2.1 To clean
the air filter" on page 15 and "13.2.3 To clean the air outlet and
outside panels" on page 16 ).
13.5 About the refrigerant
This product contains fluorinated greenhouse gases. Do NOT vent
gases into the atmosphere.
Refrigerant type: R32
Global warming potential (GWP) value: 675