Daikin FBQ20DAVMK, Руководство по эксплуатации, Страница: 10 / 32

8 English
•
Never place objects near the air inlet and the air
outlet of the unit. It may cause deterioration in the
effect or stop in the operation.
• Turn off the main power supply switch when it is
not used for long periods of time.
When the main power switch is turned on, some
watts of electricity is being used even if the
system is not operating.
Turn off the main power supply switch for saving
energy. When reoperating, turn on the main
power supply switch 6 hours before operation for
smooth running (Refer to MAINTENANCE).
Note 1: The consumed power while the
outdoor unit is stopped depends on
the model of the unit.
Note 2: The saved setting is the state before
the power circuit breaker is shut off.
(Timer settings will be erased.)
•
Do not let the air blow directly to a person.
•
When the display shows “ ” (TIME TO CLEAN
AIR FILTER), ask a qualified service person to
clean the filter (Refer to MAINTENANCE).
•
It takes time for the room temperature to reach the
set temperature.
We recommend starting the operation in advance
using timer operation.
•
Install TVs, radios, and stereos 1 m or more away
from the indoor unit and remote controller.
Images may become fuzzy and noise may be
generated.
ONLY A QUALIFIED SERVICE PERSON IS
ALLOWED TO PERFORM MAINTENANCE
WARNING
Do not use flammable materials (e.g.,
hairspray or insecticide) near the product.
Do not clean the product with organic
solvents such as paint thinner.
The use of organic solvents may cause crack
damage to the product, electric shocks, or fire.
CAUTION
• BEFORE OBTAINING ACCESS TO TERMINAL
DEVICES, ALL POWER SUPPLY CIRCUITS
MUST BE INTERRUPTED
Before cleaning, be sure to stop unit operation,
turn the breaker off or remove the power cord.
Otherwise, an electric shock and injury may result.
• Do not wash the air conditioner with water, as
this may result in electric shocks or fire.
8. MAINTENANCE
(FOR SERVICE PERSONNEL)
• Watch your steps at the time of air filter
cleaning or inspection.
High-place work is required, to which utmost
attention must be paid.
If the scaffold is unstable, you may fall or topple
down, thus causing injury.
01_EN_3PN07753-14T.fm Page 8 T hursday, January 13, 2011 3:54 PM
TIMER ON/OFF
Press the TIMER ON/OFF button.
The timer setting procedure ends.
The display “
or ” changes from
flashing light to a constant light.
Refer to figure 4 on page [1]
NOTE
• When setting the timer Off and On at the same
time, repeat the above procedure from to
once again.
When the timer is programmed to stop the system
after 3 hours and start the system after 4 hours, the
system will stop after 3 hours and then 1 hour later
the system will start.
•
After the timer is programmed, the display shows
the remaining time.
•
Press the TIMER ON/OFF button once again to
cancel programming. The display vanishes.
Observe the following precautions to ensure the
system operates.
•
Adjust the room temperature properly for a
comfortable environment.
heating or cooling.
Avoid excessive
• Prevent direct sunlight from entering a room
during cooling operation by using curtains or blinds.
• Ventilate the room reqularly.
Using the unit for long periods of time requires
attentive ventilation of the room.
• Keep doors and windows closed. If the doors and
windows remain open, room air will flow out and
cause to decrease the effect of cooling and
heating.
• Do not place other heaters directly below the
indoor unit.
They may deform due to the heat.
3
7. OPTIMUM OPERATION
1
3