Daikin EKHBRD014ABV1, Руководство по эксплуатации

Страница: 14 / 24

Operation manual
13
EKHBRD011~Y1
Indoor unit for air to water heat pump system and options
4PW60971-1
Programming space heating is carried out as follows:
1 Press the
<
button to enter the programming/consulting mode.
2 Select the operation mode you would like to program by means
of the
pi
and
pj
buttons.
The actual mode is blinking.
3 Press the < button to con fi rm the selected mode.
The actual day is blinking.
4 Select the day you would like to consult or to program by means
of the
pi
and
pj
buttons.
The selected day is blinking.
5 Press the < button to con fi rm the selected day.
6 Hold down the < button for 5 seconds to program the detailed
actions.
The fi rst programmed action of the selected day appears.
7 Use the
<
button to select the action number you would like to
program or to modify.
8 Use the
pi
and
pj
buttons to set the correct action time.
9 Use the
ébi
and
ébj
buttons to set the leaving water
temperature.
10 Use the
bi
and
bj
buttons to set the room temperature.
11 Use the
ba
button to select:
- x : to switch heating and the remote controller off.
-
a
: to select automatic temperature calculation for leaving
water temperature
Use the ébi and ébj buttons to set the appropriate
shift value (refer to "Space heating operation ( h )" on page 4 for
more information about weather dependent set point).
12 Repeat steps 7 to 10 to program the other actions of the
selected day.
When all actions have been programmed, make sure that the
display shows the highest action number you would like to save.
13 Press the
<
button for 5 seconds to store the programmed
actions.
If the < button is pressed when action number 3 is displayed,
actions 1, 2 and 3 are stored but 4 and 5 are deleted.
You automatically return to step 6.
By pressing the pr button several times, you return to previous
steps in this procedure and fi nally return to normal operation.
14 You automatically return to step 6, start again to program the
following day.
Programming quiet mode or domestic water heating
Programming domestic water heating or quiet mode is carried out as
follows:
1 Press the
<
button to enter the programming/consulting mode.
2 Select the operation mode you would like to program by means
of the
pi
and
pj
buttons.
The actual mode is blinking.
3 Press the < button to con fi rm the selected mode.
4 Select the day you would like to program by means of the pi
and pj buttons.
The actual day is blinking.
5 Press the
<
button to con fi rm the selected day.
6 Hold down the
<
button for 5 seconds to the program the
detailed actions
The fi rst programmed action of the selected day appears.
7 Use the < button to select the action number you would like to
program or to modify.
8 Use the pi and pj buttons to set the correct action time.
9 Use the ba button to select or deselect x as action.
10 Repeat steps 7 to 10 to program the other actions of the
selected mode.
When all actions have been programmed, make sure that the
display shows the highest action number you would like to save.
NOTE Returning to previous steps in the programming
procedure without saving modi
fi ed settings is done by
pressing the pr button.
NOTE Returning to previous steps in the programming
procedure without saving modi
fi ed settings is done by
pressing the pr button.