DCC601A51
intelligent Tab Controller
4P420109-1 – 2015.10
Installer reference guide
2
Installation
2.
General safety precautions
Please read these general safety precautions carefully before
installing the intelligent Tab Controller kit.
After completing the installation, make sure the power supply and
intelligent Tab Controller modules operate properly during the startup
operation.
2.1.
General
If you are not sure how to install or operate the modules, contact your
dealer.
2.2.
Installation site
Do NOT install the equipment in a potentially explosive atmosphere.
2.3.
Electrical
Install the wires at least 1 metre away from televisions or radios to
prevent interference. Depending on the radio waves, a distance of
1 metre may not be sufficient.
3.
Contents of the kit and optional
equipment
3.1.
Contents of the kit
Based on the following accessory list, check that all parts and
accessories for the intelligent Tab Controller are included in the kit. If
there is any missing or defective part, contact the Daikin dealer
where you purchased this product.
a
CPU module (1×)
b
I/O module (1×)
c
WAGO power supply unit (1×)
d
USB cable, 0.5 m (1×)
e
Installation manual (this manual) (1×)
NOTICE
Improper installation or attachment of equipment or
accessories could result in electric shock, short-circuit,
leaks, fire or other damage to the equipment. Only use
accessories, optional equipment and spare parts made or
approved by Daikin.
WARNING
Make sure installation, testing and applied materials
comply with the applicable legislation (on top of the
instructions described in the Daikin documentation).
CAUTION
Wear adequate personal protective equipment (protective
gloves, safety glasses,…) when installing, maintaining or
servicing the system.
WARNING
Tear apart and throw away plastic packaging bags so that
nobody, especially children, can play with them. Possible
risk: suffocation.
DANGER: RISK OF ELECTROCUTION
Turn OFF all power supply before connecting
electrical wiring or touching electrical parts.
Disconnect the power supply for more than 1 minute,
and measure the voltage at the terminals of main
circuit capacitors or electrical components before
servicing. The voltage must be less than 50 V DC
before you can touch electrical components. For the
location of the terminals, see the wiring diagram.
Do NOT touch electrical components with wet hands.
Do NOT leave the equipment unattended when the
service cover is removed.
WARNING
A main switch or other means for disconnection, having a
contact separation in all poles providing full disconnection
under overvoltage category III condition, shall be installed
in the fixed wiring.
WARNING
Only use copper wires.
Make sure the field wiring complies with the
applicable legislation.
All field wiring must be performed in accordance with
the wiring diagram supplied with the product.
Make sure to install earth wiring. Do NOT earth the
unit to a utility pipe, surge absorber, or telephone
earth. Incomplete earth may cause electrical shock.
Make sure to use a dedicated power circuit. NEVER
use a power supply shared by another appliance.
Make sure to install the required fuses or circuit
breakers.
Make sure to install an earth leakage protector.
Failure to do so may cause electric shock or fire.
WARNING
After finishing the electrical work, confirm that each
electrical component and terminal inside the electrical
cabinet is securely connected.
Make sure all covers are closed before starting up the
units.
a
b
c
+ + - -
L N
d
e
