Daikin Clima-Flex CLIC Series, Руководство по управлению, Страница: 21 / 30

cm-clic-cf-eng www.clima-flex.com
21
Control
Unit Capacity:
If the system has been configured with units of different capacities,
a button will be enabled on this screen, here the user can enable
the capacity of each unit individually.
Unit protection timeout
• Load time (start-up time between multiple units)
• Unload time (off time between multiple units)
• Minimum compressor cycle time
• Minimum pump stop time
• Fan start and stop delay (For air-to-water units only)
FLOW ALARM
• The detection processes for water flow are explained in the
“Pump Startup” section. The parameters to be assigned by the
user are:
• Timeout for digital input detection once the pump has been
turned on.
• Number of attempts to start the pump in case of digital input
flow detection failure.
• Waiting time between attempts to start the pump.
FREEZING AND COLD WATER ALARM
The freezing and cold water logic is the same, except that one
considers the freezing sensor and the other the injection sensor as
the main source of information.
For each of the alarms, an activation value, a reset and recovery
time (where the unit with an active alarm will not be reset) must
be set.
Each unit has an internal counter that keeps track of how many
times a freeze or cold water alarm has been activated. If the unit
exceeds a certain number of alarms in a certain amount of time,
the continuous freeze alarm will be activated, which will disable the
unit until the user resets it.
HIGH AND LOW PRESSURE ALARM
The high and low pressure alarms are activated immediately
after a change in the digital input is detected. Both alarms stop
compressor operation immediately.
The high pressure alarm is not automatically reset, the user
must perform this operation manually. The low pressure alarm is
automatically reset once a change in the corresponding digital
input is detected. When the alarm is reset, the compressor will be
disabled for the recovery time set by the user in this section.