Daikin BRC7E63W, Руководство по эксплуатации, Страница: 7 / 16

English 4
Placing the remote controller in the
remote controller holder
Install the remote controller holder to a wall
or a pillar with the attached screw. (Make
sure it transmits)
How to put the dry batteries
(1) Remove the back cover
of the remote controller
to the direction pointed
by the arrow mark.
(2) Put the batteries
Use two LR03<IEC>
dry cell batteries. Put
dry batteries correctly
to fit their (+) and (–).
(3) Close the cover
When to change batteries
Under normal use, batteries last about a
year. However, change them whenever the
indoor unit doesn’t respond or responds
slowly to commands, or if the display
becomes dark.
Placing the remote
controller
Slide from above
Remote
controller
holder
Removing the
remote controller
Pull it upward
[CAUTIONS]
• Replace all batteries at the same time, do
not use new and old batteries intermixed.
• In case the remote controller is not used
for a long time take out all batteries in order
to prevent liquid leak of the battery.
IN THE CASE OF CENTRALIZED
CONTROL SYSTEM
If the indoor unit is under centralized control, it
is necessary to switch the remote controller’s
setting.
In this case, contact your DAIKIN dealer.
Refer to figure 1 on page [1]
• Operating procedure varies with heat
pump type and cooling only type. Contact
your Daikin dealer to confirm your system
type.
• To protect the unit, turn on the main power
switch 6 hours before operation.
• If the main power supply is turned off dur-
ing operation, operation will restart auto-
matically after the power turns back on
again.
Operate in the following order.
• AUTOMATIC OPERATION can be
selected only by Heat recovery system.
• For cooling only type, “COOLING”, and
“FAN” and “DRY”operation are able to
select.
4. OPERATION PROCEDURE
COOLING, HEATING, AUTOMATIC,
FAN, AND PROGRAM DRY
OPERATION