Daikin BRC1H519K7, Инструкция для установки и пользователя

Страница: 8 / 52

4 Operation
Installer and user reference guide
8
BRK+S7
Wired remote controller
4P513689-1D – 2019.05
Dry
NOTICE
To prevent water leakage or system failure, do NOT turn
off the system immediately after indoor unit operation.
Before turning off the system, wait until the drain pump
finishes discharging any water remaining in the indoor unit
(approximately 1 minute).
INFORMATION
To ensure a smooth start, do not turn off the system while
it is operating.
4.2.2 To set the operation mode
1 Navigate to the operation mode menu.
2 Use and to select an operation mode.
3 Press to activate.
Result: The indoor unit changes its operation mode and the
controller returns to the home screen.
4.3 Setpoint
The setpoint is the target temperature for the Cooling, Heating, and
Auto operation modes.
4.3.1 About the setpoint
Home screen setpoint
Depending on configuration, the home screen displays the
temperature setpoint either as a numerical value, or as a symbol.
Numerical Symbolic
In case the setpoint is a
numerical value, you control the
room temperature by raising or
lowering the setpoint by 1°C
increments. In case the setpoint is a symbol,
you control the room temperature
by raising or lowering the
setpoint in relation to the
"reference setpoint" (visually
indicated by the marker in the
middle of the thermometer). It is
possible to raise the setpoint
three steps of 1°C above and
three steps of 1°C below the
reference setpoint.
Example: if the reference
setpoint is 25°C, it is possible to
raise the setpoint to 28°C and
lower it to 22°C..
28°C
+3°C
-3°C
25°C
22°C
INFORMATION
Setpoint control is limited by any limitations set to the
setpoint
range. For more information, see
"14.5.21 Setpoint range" on page 40 .
▪ Numerical : it is only possible to raise or lower the
setpoint up/down to the maximum/minimum setpoint
range limits.
▪ Symbolic : it is only possible to raise or lower the
setpoint up/down to the maximum/minimum setpoint
range limits, despite the set reference temperature.
Example: if the reference temperature is 25°C, you
can normally lower the setpoint three steps to 22°C.
However, if the minimum setpoint range limit is set to
24°C, you can only lower the setpoint to 24°C.
INFORMATION
For how to set the home screen setpoint and configure the
reference setpoint, see the Madoka Assistant app.
4.3.2 To set the setpoint
Prerequisite: The active operation mode is either 'Cooling',
'Heating', or 'Auto'.
1 In the home screen, use and to adjust the setpoint.
Result: The indoor unit changes its temperature setpoint.
4.4 Date and time
Set the date and time for the indoor units connected to the controller.