Daikin Altherma EVLQ05+08CA, Руководство по установке для специалистов

Страница: 50 / 252

6 | Preparation
Installer reference guide
50
EHYH EHYHBH/X08AF + EHYKOMB33AA
Daikin Altherma hybrid heat pump
4P355634-1F – 2020.10
Installation
height
difference
(a)
Water volume
≤140 l >140 l
≤7 m No pre-pressure adjustment is
required. Do the following:
▪ Decrease the pre-pressure.
▪ Check if the water volume
does
NOT exceed the
maximum allowed water
volume.
>7 m Do the following:
▪ Increase the pre-pressure.
▪ Check if the water volume
does
NOT exceed the
maximum allowed water
volume.
The expansion vessel of the
indoor unit is too small for the
installation. In this case, it is
recommended to install an
extra vessel outside the unit.
(a) This is the height difference (m) between the highest point of the water circuit and
the indoor unit. If the indoor unit is at the highest point of the installation, the
installation height is 0 m.
Minimum flow rate
Check that the minimum flow rate (required during defrost/backup heater
operation) in the installation is guaranteed in all conditions.
Minimum required flow rate
05 models 7 l/min
08 models 8 l/min
NOTICE
When circulation in each or certain space heating loops is controlled by remotely
controlled valves, it is important that the minimum flow rate is guaranteed, even if all
valves are closed. In case the minimum flow rate cannot be reached, a flow error 7H
will be generated (no heating or operation).
See the recommended procedure as described in "10.4 Checklist during
commissioning" [ 4 185].
6.4.4 Changing the pre-pressure of the expansion vessel
NOTICE
Only a licensed installer may adjust the pre-pressure of the expansion vessel.
The default pre-pressure of the expansion vessel is 1 bar. When it is required to
change the pre-pressure, take following guidelines into account:
▪ Only use dry nitrogen to set the expansion vessel pre-pressure.
▪ Inappropriate setting of the expansion vessel pre-pressure will lead to
malfunction of the system.
Changing the pre-pressure of the expansion vessel should be done by releasing or
increasing nitrogen pressure through the Schrader valve of the expansion vessel.