Daikin Altherma EHVZ04S18CB, Руководство по установке для специалистов

Страница: 25 / 92

7 Installation
Installer reference guide
25
ERLQ004~008CA + 08S18CB
Daikin Altherma – Low temperature split
4P401676-1D – 2018.07
INFORMATION
If you install the U-beams in combination with the low
sound cover (EKLN08A1), different installation instructions
apply for the U-beams. See the installation manual of the
low sound cover.
a
b
c
a Low sound cover
b Bottom parts of the low sound cover
c U-beams
7.3.4 To install the outdoor unit
CAUTION
Do NOT remove the protective cardboard before the unit is
installed properly.
1 Lift the outdoor unit as described in "3.2.2 To remove the
accessories from the outdoor unit" on page 7 .
2 Install the outdoor unit as follows:
2×
2
a a
1
a Air outlet
NOTICE
The pedestal MUST be aligned with the backside of the
U‑beam.
3 Remove the protective cardboard and instruction sheet.
b
a
a Protective cardboard
b Instruction sheet
7.3.5 To provide drainage
▪ Avoid installation places where water leaking from the unit due to
a blocked drain pan can cause damage to the location.
▪ Make sure that condensation water can be evacuated properly.
▪ Install the unit on a base to make sure that there is proper
drainage in order to avoid ice accumulation.
▪ Prepare a water drainage channel around the foundation to drain
waste water away from the unit.
▪ Avoid drain water flowing over the footpath, so that it does NOT
become slippery in case of ambient freezing temperatures.
▪ If you install the unit on a frame, install a waterproof plate within
150 mm of the bottom side of the unit in order to prevent water
from getting into the unit and to avoid drain water dripping (see the
following figure).
NOTICE
If the drain holes of the outdoor unit are blocked up,
provide space of at least 300 mm below the outdoor unit.
An additional drain pan kit (EKDP008CA) can be used to gather the
drain water. The drain pan kit consists of: