SVLC-212-175
13
4.2 The kind of display
4.2.1 Measurement display
The change of the measurement display factor of the main monitor by switch operation and the change of
the line / phase display of voltage is possible (temporarily).
In a general measurement display, if switch operation is not performed for 10 minutes after changing a
display factor, it returns to the original measurement display factor automatically.
Voltage, frequency, etc. indicate the
measurement value of four factors by the
maximum.
Setting which always displays a measurement
factor is possible. And, it is possible to
change to a display of the maximum value and the
minimum value, about the measurement factor
which performs holding of the maximum value and
the minimum value by switch operation.
These maximum values and the minimum value are
reset by switch operation (it updates to the
instantaneous value at the time).
In addition, as for the maximum value and the
minimum value, power-supply reset is not
cleared either. And, this display is held by
even after 10 minutes of switch non-operation.
・The example of a measurement display of each measurement factor (Main monitor)
Measurement factor
Example of display
Voltage
V
Frequency
Hz
General measurement display
V(UV) display
V(VW) display
General measurement
maximum and minimum display
Instant display
Range of minimum to maximum
is displayed in bar graph.
Minimum display
V(WU) display
Hz display
Maximum display
