No. U5279
P. 11 / 25
7. WELDING PREPERATION
7.1 Fitting of Wire
1. Loosen the screw to clamp the cap knob.
2. Detach the cap knob from the wire reel shaft.
3. Mount the wire reel on the wire reel shaft.
NOTE: Check the positions of the wire reel stop pin and the wire reel stop hole to insert and
fully seat the pin into the hole.
4. Firmly tighten the cap knob.
5. Align the hole in the cap knob with the wire reel stop hole, then cap the wire reel hole with the
clamp screw to prevent the cap knob from dropping.
6. Bring down the pressure handle, then raise the pressure roll holder.
7. After pulling out the wire, thread it from the pilot to outlet guide through the center guide.
8. Return the pressure reel holder first, the pressure handle.
CAUTION
●
When hanging the wire feeder, firmly fix
the cap knob and clamp screw
in
position to prevent the device from
dropping.
Wire reel shaft
Wire reel stop pin
Clamp screw
Cap knob
Wire reel stop hole
Pressure handle
Outlet guide
Pressure roll holder
Center guide
Pressure handle
Pilot
To tighten the cap knob, turn the
knob clockwise.
To loosen the cap knob, turn the
knob counter-clockwise.
