DAIHAN-Sci.com or
ALL
for
LAB.com
Shopping Mall
DAIHAN Scientific, Forced Convection type Smart Incubator 7/81
2. Installation
2.1 Product Installation
* Caution of Installation
1.
Please be careful when transporting the product because it is heavy.
2.
Please do not lay the product on the floor or subject it to shock. It can cause damage inside
the product.
3.
Please install the product in a hard, flat, and stable place.
4.
Please do not install the product in a place where it is exposed to direct sunlight, or in the
dangerous places.
5.
To minimize the risk of short circuits, do not install the product (in the) places where it will
be subjected to the inflow of moisture or organic solvents on the regulator part or inside of
the body.
6.
This product was manufactured for normal operation at a rated voltage, so please check the
voltage status before installing the product.
7.
When installing and using the product, please certainly use the power cord provided with
the products.
* Installation Process
1.
After receiving the unit and locating it in the specified location, remove the packaging.
2.
Check the unit for any transport damages. If any such damages are found, please contact
the deliverer of the product.
3.
This Product is not equipped with casters. Units should be moved using a cart. Ensure that
no damage is sustained by the units during transport. It is recommended that units are
moved by at least 2 people and by lifting units up holding the indicated positions in the
figure below.
4.
The product should be positioned in a location where it has enough space for ventilation
and prevention from fire. The recommended distance of each side is minimum 20cm from
the back wall, 100cm from the side walls and ceiling respectively.
2
