Dahua VTO12 Series, Руководство пользователя

Страница: 25 / 49

2
3.1.2 Configure VTO
Configure VTO info, make sure there is communication among center, VTO and VTH.
Note:
Access VTO WEB config interface via PC, and please make sure PC and VTO both
connect to the Internet and are in the same segment.
Step 1. Login WEB.
Via PC remotely access VTO. In Internet Explorer, input IP address of the VTO
and enters VTO WEB login page.
You must input username and password in order to login WEB main interface.
Click on login.
Default username: admin
Default password: admin.
Step 2. Set device info.
a) Select System Config>Local Config.
b) Set system type to digital (Tcp/IP), video format is WVGA, and set frame rate
according to your condition. Click on OK. See Figure 3- 2.
Figure 3- 2
Step 3. Set LAN.
a) In page, select System Config>LAN Config, enter LAN Config interface.
b) The default config can ensure VTO and VTH are connected. If you want to
configure center, the setup shall match setup in center and check register to the
MGT center in LAN Config. See Figure 3- 3.