Now device interface shows
at the upper-right corner which means wireless connection is
successful.
Wired:
1. Select Wired. See Figure 4-4.
Figure 4-4
2. Enter VTH Local IP, Subnet Mask and Gateway.
3. Press OK.
Now device interface shows
at the upper right corner which means wired connection is
successful.
Note:
You also can enable DHCP to auto gain VTH IP, subnet mask and gateway and press OK
to complete wired connection.
Step 5. Press Production to config VTH room no.
Warning:
VTH room no. must match VTH short no. on WEB of corresponding VTO.
If you want to set this VTH to be master VTH, then you shall select Master.
Fill in room no., press OK to save, see Figure 4-5.