6
Step 1
Install the default pedestal seal ring of the speed dome on the bracket according to the way
shown in Figure 3-2.
Step 2
Confirm installation position and outlet mode first, dig holes on the ceiling according to the
installation position map, and then put the three plastic expansion bolts into the holes you just
dug.
Step 3
Unscrew three locking screws on the enclosure by using inner hex wrench, and remove the
enclosure.
Step 4
Lay the outgoing line according to the outlet mode, and use three self-tapping screws to fix the
pedestal on the installation surface, and insert the screws into the expansion bolts.
Step 5
Use three locking screws to fix the dome enclosure on the pedestal.
So far, the camera installation is completed, and you can adjust the lens angle, zoom, focus and
etc on the WEB interface.
