Dahua RG11/U, Руководство по установке

Страница: 15 / 30

8
Open speed dome rear cover, you can see the dial switch buttons on the PTZ main board. You
can follow the steps listed below to set the speed dome address, baud rate, and HD/SD video
format.
Please note you need to restart the device to activate the new setup!
There are two dial switch buttons on the PTZ of intelligent speed dome. You can use them to set
speed dome address, baud rate, and HD/SD video format respectively. It is 1 when you set the
button as ON.
For address dial switch, 1 is the lowest bit and the 8 is the highest bit.
For baud rate and HD/SD video format setup, 1 is the lowest bit and the 4 is the highest bit. See
Figure 2-3.
Please note the intelligent speed dome can self-adapt PELCO-D. PELCO-P and industrial
standard protocol, the control protocol
doesn’t have to be set via dial.
Figure 2-10
2.4.3 Baud Rate and HD/SD Video Format Setup
For the dial switch button 1-4. 1 and 2 is to set baud rate. 3 and 4 is to set HD/SD video format.
Please refer to the following figure for detailed information. See Figure 2-11.
Figure 2-11
Please refer to the baud rate sheet for detailed information.
1 2 Baud Rate
OFF OFF 9600bps
ON
OFF 4800bps
OFF
ON
2400bps