13
2
Operation
The following operations are generally based on the 9-channel high definition
series product.
Slight different may be found in the user interface.
2.1
Boot Up and Shut Down
Boot up
Connect the device to the power and then press the power button in the rear panel. You
can see the power indicator light becomes on and device boots up.
The system is in multiple-window display mode by default.
Shut down
You can press power button in the front panel for three seconds to shut down the device.
System Restore after Power Failure
When decoder is working, if the power failure occurs, the system can automatically
connect to the front-end device and restore previous working status once the power
connection becomes normal.
2.2
Login
2.2.1 Preparation
Before log in, please make sure:
Device connection is OK.
You have set PC IP address, device IP address, subnet mask and gateway. (Please
set the IP address of the same section for the PC and device. Please input
corresponding gateway and subnet mask if there are routers.). When device booted
up normally, please input account name
admin
and password
admin
via the PC
COM port., then input net
–
a and then input IP, NETMASK, GATEWAY. The
command mode is: net -a [IP] [NETMASDK] [GATEWAY].
For example:
Username: admin
Password: admin
DeBug>net -a 192.168.XXX.XXX 255.255.XXX.XXX 192.168.XXX.XXX
Use order ping ***.***.***.***(Device IP address) to check connection is OK or not.
Usually the return TTL value should be less than 255.
Open IE and then input the address in the column.
WEB control can be downloaded and installed automatically. System can download
the latest Web control and remove the old one.
You can run uninstall web.bat to remove the control