12
4.1 Installing the Camera
1. Remove the camera, the mounting template, and the hardware package from the box.
2. Use the Hex Key to loosen the three enclosure set screws and then remove the dome enclosure.
4.2 Inserting the Micro SD Card (optional)
Figure 4-2
1. Open the Micro SD slot cover.
2. Insert the Micro SD card (maximum of 128 GB) into the slot shown above.
3. Close the slot cover.
4.3 Mounting the Camera
1. Determine the route of the power and the Ethernet cables: Bottom wiring exit through the
installation medium or side wiring exit.
2. Apply the mounting template to the mounting medium. Pre-drill the three (3) perimeter holes for
the expansion bolts, using a drill bit that is no wider than the expansion bolt.
3. If routing wires through the installation medium, drill the center hole to route the cables from the
camera through the installation medium.
4. Insert an expansion bolt into each pre-drilled perimeter hole.
5. Attach the waterproof network connector if the camera is used outdoors.
Figure 4-3
a. Place the wide side of the rubber ring onto the end of the network cable extending out
from the camera.
b. Pull the waterproof cable end without the Ethernet connector through the body of the
Waterproof Connector. Thread the cable through the Fixing Rubber Ring and the
Waterproof Locking Cover.
c. Attach the male Ethernet connector to the network cable coming from the camera.
Ensure the Waterproof Connector shroud covers the Ethernet connection.
