Dahua N53AJ52, Быстрое руководство по установке

Страница: 21 / 28

10
Mounting the Camera
Remove the camera, the mounting template, and the hardware package from the box.
Apply the mounting template to the installation medium. Pre-drill the three (3) perimeter
holes for the expansion bolts, using a drill bit that is no wider than the expansion bolt.
Detach the camera body from the installation base. Use a T10 driver to remove the Torx
fastener from the front of the camera. Carefully remove the camera body and housing from
the base.
Determine the wire route, either through the installation medium or through side conduit on
the camera base. Refer to the illustrations below.
Drill a center hole to route the cables from the camera through the installation medium.
Insert an expansion bolt into each pre-drilled perimeter hole.
Secure the installation base to the installation medium with the three screws.
Route the cables from the back of the camera through the installation medium or via the
camera base conduit and align the three (3) holes on the base of the camera with the
expansion bolts.
Fir the camera body into the installation base and then place the housing over the camera.
Secure the camera body and housing to the installation base with the T10 fastener.
Connect the external cables from the camera to the appropriate cables for Ethernet and
power.
2.5.1 Mounting to a Wall: Cables through Surface