7
Remove the camera, the mounting template, and the hardware package from the box.
Apply the mounting template to the installation medium. Pre-drill the three (3) perimeter
holes for the expansion bolts, using a drill bit that is no wider than the expansion bolt.
Determine the wire route, either through the installation medium or through side conduit on
the camera base. Refer to the illustrations below.
Drill a center hole to route the cables from the camera through the installation medium.
Insert an expansion bolt into each pre-drilled perimeter hole.
Route the cables from the back of the camera through the installation medium or via the
camera base conduit and align the three (3) holes on the base of the camera with the
expansion bolts.
Secure the camera to the installation medium with the four screws.
Connect the external cables from the camera to the appropriate cables for Ethernet and
power.
2.5.1 Mounting to a Wall: Cables through Surface
