Dahua N45DB7Z, Быстрый старт, Страница: 9 / 21

Introduction 2
No. Port
Name
Function Description
3 Audio
input
Connects to sound-pick-up device to receive audio signal.
4 Audio
output
Connects to speaker to output audio signal.
5 Alarm I/O Alarm signal input/output.
For more information about I/O port, see Table 1-2.
Table 1-2 Alarm Information
Port Port Name Function
Alarm I/O
ALARM_OUT
Outputs alarm signal to alarm device.
When connecting to alarm device, only the ALARM_OUT port and
ALARM_OUT_GND port with the same number can be used together.
ALARM_OUT_
GND
ALARM_IN1
Receives the switch signal of external alarm source.
Connect different alarm input devices to the same ALARM_IN_GND
port.
ALARM_IN2
ALARM_IN_G
ND
1.2 Connecting Alarm Input/output
Alarm input/output is available on select models.
Connect alarm input device to the alarm input end of the I/O port, see Figure 1-2. Step 1
Device collects different states of alarm input port when the input signal is idling and
being grounded.

Device collects logic "1" when input signal is connecting to +3V to +5V or idling.

Device collects logic "0" when input signal being grounded.
Alarm input Figure 1-2
Connect alarm output device to the alarm output end of the I/O port. The alarm output Step 2
is open-drain output, which works in the following modes.

Mode A: Level application. Alarm outputs high and low level, and the alarm outlet
is OD, which requires external pull-up resistance (10K Ohm typical) to work. The
maximum external pull-up level is 12V, maximum port current is 300mA and the
default output signal is high level (external pull-up voltage). The default output
signal switches to low level when there is alarm output (As long as the operating
current below 300mA, the output low level voltage is lower than 0.8V).