4
Figure 3-3
Figure 3-4
Step 1
Use the inner hex wrench from the accessories bag to unfasten the 3 hex screws on the dome
camera enclosure and then open the dome enclosure.
Step 2
Take the installation position map (shown in Figure 3-1) from the accessories bag and then
paste it on the installation ceiling or the wall according to the monitor area. Please dig three
bottom holes of the plastic expansion bolts according to the diagram. Take three expansion
bolts from the accessories bag and then insert them to the holes you just dug and then fix
firmly.
Note:
If you need to dig a hole to pull through the cable on top of installation surface, you need
to dig a cable exit hole on the installation surface according to the installation positioning
map.
If you need to pull through the cable on the side, you need to dig through the U-shape exit
hole on the side of chassis to form a cable access, and then pull the cable through the
side exit hole on the chassis.
Step 3
Adjust the device chassis
and pull the cable through the exit hole. Make “TOP” direction of the
device identical with installation position map. Make sure the 3 fixture holes on chassis face
