Dahua Technology D-TPC-BF1241-B3F4-DW-S2, Руководство по работе в сети

Страница: 28 / 158

19
4.2.1 Configuring Protocol
If you want to control the external PTZ by the Camera, you need to set the PTZ protocol first and
then connect PTZ to the Camera.
Step 1
Select Setting > System Management > PTZ Setting .
Step 2 Configure PTZ parameters.
Figure 4-7 PTZ settings
Table 4-4 Parameter description
Parameter Description
Protocol Matches with the PTZ protocol.
Address
Enter the corresponding camera address.
The address must be the same with the address configured on the PTZ;
otherwise the Camera cannot control the PTZ.
Baud rate Configure camera baud rate.
Data bit It is 8 by default.
Stop bit It is 1 by default.
Parity It is None by default.
Step 3 Click Save .
4.2.2 Configuring PTZ Functions
●
The protocol setting has been completed. For details, see "4.2.1 Configuring Protocol".
●
View the image that represents the effect of external PTZ through the external PTZ, not the
Camera.
●
The following functions are available only when the Camera is connected to the external PTZ.
4.2.2.1 Configuring Preset
Preset means a certain position that the Camera can make quick orientation to. It includes PTZ pan