12
4.3 Mounting the Camera to a Wall
1. Place the PFB300S Wall Mount against the wall and mark the location of the center hole and the
four perimeter mounting holes.
2. Pre-drill the four perimeter holes as marked on the wall for the expansion bolts, using a drill bit
that is no wider than the expansion bolt.
3. Drill a 50-mm (approximately 2 in.) center hole to route the cables, if necessary.
4. Insert an expansion bolt into each pre-drilled perimeter hole, if necessary.
5. Wrap several turns of Teflon tape around the threads on the PFA110 Mount Adapter.
6. Screw the PFA110 Mount Adapter block into the internal thread of the wall mount bracket until
secure. Tighten the set screw on the wall mount to secure the mount adapter.
7. Secure the PFB300S Wall Mount to the wall using the four (4) fasteners.
8. Pull the composite cable from the dome through the adapter block and pull it out of the other end
of the wall mount bracket.
