Camera Installation
6
Place the mounting template against the ceiling and mark the location of the center hole
and the three perimeter mounting holes.
Determine the route of the outgoing cables, either a center route through the ceiling
medium or a side exit to a grounded conduit. If the cables are routed through the ceiling,
then place the pedestal seal ring into the slot on the side of the camera base.
Pre-drill the three perimeter holes as marked on the wall for the expansion bolts, using a
drill bit that is no wider than the expansion bolt.
Drill a 50-mm (approximately 2 in.) center hole to route the cables, if necessary.
Insert an expansion bolt into each pre-drilled perimeter hole, if necessary.
Pull the composite cable from the dome through the ceiling.
Align the screw holes in the pedestal with the pre-drilled perimeter holes.
Secure the pedestal to the ceiling with the three screws.
Use the hex wrench to secure the three screws in external enclosure to the pedestal.
Attach the waterproof network connector if the camera is used outdoors.
a) Place the wide side of the rubber ring onto the end of the network cable extending out
from the camera.
b) Pull the waterproof cable end without the Ethernet connector through the body of the
Waterproof Connector. Thread the cable through the Fixing Rubber Ring and the
Waterproof Locking Cover.
c) Attach the male Ethernet connector to the network cable coming from the camera.
Ensure the Waterproof Connector shroud covers the Ethernet connection.
d) Connect the other end of the waterproof connector to the network port and rotate it
clockwise to lock the network port and waterproof connector firmly.
e) Slide the Waterproof Locking Cover over the main body of waterproof connector and
rotate it clockwise to seal the connection.