Dahle 35314, Инструкция

Страница: 2 / 19

1
7
en
Instructions
IMPORTANT!
Read the operating and safety instructions
BEFORE placing the document shredder
into operation.
You must follow the instructions.
Keep the operating instructions in a safe
place ready for later use.
Table of Contents
1 Important information . . . . . . . . . . . . . . . 7
1.1 Intended use, warranty . . . . . . . . . . . . . . . 7
1.2 Safety instructions . . . . . . . . . . . . . . . . . 8
1.3 Key to pictograms . . . . . . . . . . . . . . . . . 9
1.4 Scope of supply . . . . . . . . . . . . . . . . . . 62
1.5 Technical specifications . . . . . . . . . . . . . 62
2
Operation . . . . . . . . . . . . . . . . . . . . . . 63
2.2 Connecting the device to the main supply 63
2.3 Switch on the device . . . . . . . . . . . . . . 63
2.4 Paper shredding . . . . . . . . . . . . . . . . . 64
2.10 Continuous operation . . . . . . . . . . . . . . . 66
2.11 Loocking . . . . . . . . . . . . . . . . . . . . . . . . 67
2.14 CD, DVD & card shredding . . . . . . . . . . . . 68
3
Maintenance / troubleshooting . . . . . . . . 70
3.1 Emptying shredding waste . . . . . . . . . . . . 70
3.3 bin/lid open . . . . . . . . . . . . . . . . . . . . . 70
3.4 Overheated . . . . . . . . . . . . . . . . . . . . . . 71
3.5 Paper jam manual feed . . . . . . . . . . . . . . 71
3.7 Paper jam automatic feed . . . . . . . . . . . . 72
3.10 Paper jam locked automatic feed . . . . . . . 73
3.13 Emergency release . . . . . . . . . . . . . . . . . 74
3.17 Cleaning the shredder . . . . . . . . . . . . . . . 75
1.1 Intended use, warranty
The document shredder is intended to be used for
shredding paper.
Depending on the model variant, a small amount of
the following materials can also be shredded:
- CDs/DVDs, bank cards and credit cards (see techni-
cal data).
- The normal staples and paper clips found in paper
documents (exception: security level P6 and P7
devices).
This device is equipped with an automatic feeder
for paper stacks consisting of unfolded single sheets
(max. 100g/m²). Stapled paper, with paper clips as
well as with staples, usually can be processed as
well. Therefore it is mandatory, that the clamps and
paper clips must be positioned at the rear end of the
paper tray (facing away from the user)
To extend the life of the device, it is however recom-
mended to remove paper clips/clamps before shred-
ding. In individual cases, depending on the quantity
and position of the paper clips/staples and the
thickness of the stapled paper stack, a misfeed can
occur and the shredding process may be interrupted
Wear, damage due to improper use or unauthorised
modifications and repairs are not covered by the
warranty or the guarantee.
The document shredder was designed for private use
and for use in normal office environments.
The following conditions apply to the performance in
terms of sheets listed under technical data:
Maximum number of sheets that are shredded in one
pass under the following conditions: New cutting roll-
ers, oiled if needed, cold motor, power supply with