Dahle 20606 C, Руководство по эксплуатации

Страница: 8 / 12

8
READ ALL INSTRUCTIONS BEFORE OPERATING YOUR SHREDDER
Installation of the automatic oiling system
1. Be certain shredder is off and unplugged.
2. Remove protective caps (1) from mounting holes and secure Automatic Oiler to shredder
using supplied screws (3).
3. Push oil supply tube (6) fully over brass hose barb (7).
4. Place white nylon hose clamp over supply hose and position it near the bottom of
supply tube where it covers the hose barb. Squeeze clamp to tighten.
5. Insert open end of oil supply tube into grey hose fitting (5) being sure it is fully inserted.
Gently pull hose to check that it is seated properly. Hose can be removed by pressing
grey collar in and pulling on hose.
6. Remove red protective cover (8) from female DIN connector (9) and insert male DIN
plug (10) from the oiler. Connector is keyed to ensure proper alignment. Secure using
screw-in flange.
7. Fill reservoir (2) with Dahle 740 Shredder Oil.
8. Prime system by moving silver plunger up and down until supply tube is filled with oil.
9. Plug shredder into outlet and begin shredding.
NOTE:
WHEN OIL LEVEL DROPS BELOW
MINIMUM THE SHREDDER WILL STOP,
THE BAG-FULL INDICATOR WILL LIGHT
AND AN AUDIBLE ALARM WILL SOUND.