5
1. Remove paper from Feed Opening. The REVERSE button (7a) may be used if
excess paper remains in the Feed Opening (not on Model 20394). Clear
shredding mechanism by pressing the FORWARD button (7).
2. Separate some of the sheets and continue shredding.
20394
1. In case of a paper jam the shredder runs backwards for 0,5 sec.
2. Remove paper from feed opening. Clear shredding mechanism by pressing the
FORWARD button (7). The REVERSE button (7a) is locked until the FORWARD
button (7) has been pressed.
3. Separate some of the sheets and continue shredding.
CHANGING THE SHRED BAG
When the Shred Bag is full, the shredder will automatically shut down. On the elec-
tronic models an LED indicator will light and an audible alarm will sound. Changing the
Shred Bag is quick and easy if you follow these simple directions.
1. Turn shredder off
2. Open Door (11) using Door Handle (10) to expose Waste Bin (9) and Shred Bag.
3. Slide Waste Bin and full Shred Bag from shredder.
4. Dispose of full Shred Bag.
5. Install new Shred Bag in Waste Bin, draping end of Shred Bag over the lip of
the Waste Bin.
6. Slide Waste Bin, with new Shred Bag installed, back into shredder.
7. Close Door.
8. Turn on shredder and continue shredding.
CARING FOR YOUR SHREDDER
Clean covers with a clean dry cloth. Do not use water or solvents. Make sure you
disconnect your shredder from its power source before cleaning.
Paper shredders, like all mechanical equipment, need proper maintenance to ensu-
re efficient operation. Periodic lubrication of the cutting blades is important to offset
the friction generated within the cutting head. Frequency of lubrication will vary
depending on the shred size and the amount of usage. A strip-cut shredder recei-
ving light use (1 – 2 hours per week) will require lubrication only once or twice a
month, while the same machine used 1 – 2 hours per day will require lubrication
weekly. A cross-cut shredder should be lubricated every
1
/
2
hour of shredding time
to maintain maximum capacity and efficiency.The procedure for lubricating your
shredder is simple, and can be performed by any operator. The oil is packaged in a
squeeze bottle and is applied directly to the cutting blades through the feed opening
(3). Run a fine stream of lubricant from one side of the feed opening to the other.
Run the shredder in REVERSE for a few seconds to help distribute the lubricant
evenly. You can now continue shredding as usual.
NOTE: SHREDDER WILL NOT OPERATE UNLESS DOOR IS COMPLETELY CLOSED
