Chapter 11 Coiling, Taping and Zigzag Embroidery
118
BECS-D19 User’s Manual
Press
“
”
to save the setting or
“
”
to cancel it. For the related information of each
parameter, please refer to Appendix 1.
The remarks of these parameters are as below:
1. D28 Special Head Interval:
Range: 0
～
300, Default Value: 150, 162, 166, 185, 200, 216, 225, 230, 240, 250, 270, 290,
and 300
If you input the default value, there will be a “*” before the value
2. D30 Presser Foot Work Height: 0~90
This parameter is to adjust the lifting height of presser foot at each stitch.
3. D40 Presser Foot Height Limit Adjustment: 0~250
This parameter is to set the maximum lifting height of the presser foot.
4. D31 ZIG Rod Origin: Left/ Right
This parameter determines the position of swing rod when M axis is in origin and must be
set in accordance with actual mechanical position.
5. C38 Frame Swing at ZIG (-10.0
～
-0.2, +0.2
～
+10.0)
The parameter is for Z5 embroidery and applies to thick cords. For thick cord embroidery,
at Z5 embroidery, the system moves the frame to compensate the swinging scope of the lever.
The parameter’s absolute value should be set according to the cord width. And the “+/-” is
decided by the mechanical structure. The moving directions of the lever and frame should be
the same. Otherwise please change the “+/-” setting.
6. D42 Angle Compensation of M-axis: 0~10
The M axis of special embroidery head has mechanical clearance, so it will generate the
mechanical difference after M axis changes rotating direction repeatedly. At embroidering the
flat tapes, if the shape of tape is curve and the M axis has no angle compensation, the needle
will fall at the edge of the tape instead of the center of tape, which may influence the
embroidery effect.
During machine debugging, parameter value should be “0” when needle falls in the center
of tape. If not, please repeat the adjustment to realize the best effect.
Generally, this parameter should be managed by professional experts before leaving
factory.
7. D44 M-axis Work OFF Angle: 0, 90
In normal or sequin embroidery, if this parameter is set at 0, the M axis will stop at the
horizontal position; if it is set at 90, the M axis will stop at the vertical position. When the
distance between the normal embroidery head and special embroidery head is small, this
parameter must be set as 90° to avoid clashing between M axis mechanical structure and flat
embroidery head.
8. D39 Z-axis Control Shift Angle: 0~180
When the rotating angle is larger than the set value, the Z axis will swing faster.
9. D41 Swing Rod Starting Angle Adjustment: 1~3
It is the starting angle of the rod, which indicates the relative position of the needle bar
and tape. It is used for adjusting the embroidery quality. “1” means the swing starts at an early
