Focus Adjustment (mechanical back-focus)
The Back-Focus is calibrated at the factory and should not
need readjustment, however if adjustment is necessary follow
the procedure below:
1. Loosen the set screws on the top and bottom of front
casting with a 1.5mm hex wrench.
2. Set the lens to maximum aperture and to
∞
focus
position.
3. View an object which is 20M or more away, then adjust
lens mount ring until the image is in focus.
4. Tighten the set screws.
Connector pin-outs
OSD Keyboard Connector
This 8 pin connector is used for the OSD
Remote to set-up or change camera function
settings. The pin-out is as follows:
1.
RIGHT 5.
MENU
2.
LEFT
6.
ONE
PUSH(AWB)
3.
UP 7.
GROUND
4.
DOWN 8.
N/C
Y/C Video Connector
This 4 pin connector provides Y (luminance)
and C (color) output signals to be terminated
into 75
Ω
. The pin-out is as follows:
1. GROUND
3. Y (LUMINANCE)
2. GROUND
4. C (COLOR)
Содержание DC-200
Страница 1: ...User s Manual DAGE MTI DC 200 Color Camera...
