Daga HU-350, Инструкция по применению

Страница: 10 / 24

10
ENGLISH
INSTRUCTIONS FOR USE
Make Sure the humidifier is switched off and disconnected from the
electrical outlet.. Place the humidifier on a flat surface, about 60cm
away from the floor and 10cm away from the wall.
FILLING THE TANK
Instructions to fill the water tank, to do so take the handle grip (D)
and lift it up, remove the cap of the water tank placed at the bottom
and turn left (c) and fill the tank with tap water. Do not use hot water
for this.
After filling the tank, replace the cap by turning it clockwise and then
replace the water tank on the base.
Plug in the power cable and turn the control knob (E) to allow steam
to escape, adjust it to your convenience.
MAINTENANCE AND CLEANING
Remove the batteries when you do not intend to use the product for
an extended period of time to prolong its shelf-life. Let it cool down
before storing it.
Be sure to unplug the device from the network to clean the product.
The device can be cleaned with a damp cloth, do not use any
chemicals.
In the event that the water is hard, it can cause an excess of lime
which can cause obstruction in the transducer keeping the steam
inside the device. To prevent this we recommend:
APPLIANCE DESCRIPTION
1) Use cooled boiled water or distilled water.
2) Clean the transducer unit and water tank each week.
3) Remember to remove the water tank and dry the water tank before
storing the device for a long period of time.
Cleaning the transducer:
1) Put 5-10 drops of cleaning detergent on the transducer surface,
wait for 2-5 minutes;
2) Wipe or brush the surface to remove any traces of lime.
3) Rinse the transducer with clean water.
Cleaning the water tank:
1) Clean the water tank with a soft cloth and detergent cleaning if
there were traces of lime.
2) Rinse the water tank with clean water.