IMPORTANT SAFEGUARDS
3
IMPORTANT SAFEGUARDS
2
For your protection, please read these safety instructions completely before operating
the appliance, and keep this manual for future reference.
Carefully observe all warnings, precautions, and instructions on the appliance, or the
ones described in the operating instructions and adhere to them.
USE
Power Sources
– This set should be operated
only from the type of power source indicated on
the marking label. If you are not sure of the type
of electrical power supply at your home, consult
your dealer or local power company. For those
sets designed to operate from AC90-250V~,
50/60Hz.
Overloading
– Do not overload wall outlets,
extension cords or convenience receptacle
beyond their capacity, since this can result in fire
or electric shock.
Grounding or Polarization
– This set is
equipped with a polarized AC power cord plug (
a plug having one blade wider than the other), or
with a threewire grounding type plug (a plug
having a third pin for grounding).
Follow the instructions below.
Attachments
– Do not use attachments not
recommended by the manufacturer, as they
may cause hazards.
Cleaning
– Unplug the set from the wall out let
before cleaning or polishing it. Do not use liquid
cleaners or aerosol cleaners. Use a cloth lightly
dampended with water for cleaning the exterior
of the set.
Object and Liquid Entry
– Never push objects
of any kind into the set through openings as
they may touch dangerous voltage points or
shart out parts that could result in a fire or
electric shock. Never spill liquid of any kind on
the set.
Water and Moisture
– Do not use powerline
operated sets near water- for example, near a
bathtub, washbowl, kitchen sink, laundry tub, in
a wet basement, or near a swimming pool, etc.
Accessories
– Do not place the set on an
unstable cart, stand, tripod, bracket, or table. The
set may fall, causing serious injury to a child or
an adult, and serious damage to the set. Use
only a cart, stand, tripod, bracket, or table
recommended by the manufacturer.
MOISTURE CONDENSATION
Ventilation
– The slots and openings in the
cabinet are provided for necessary ventilation. To
ensure reliable operation of the set, and to
protect it from overheating, these slots and
openings must never be blocked or covered.
– Never cover the slots and openings with a cloth
or other materials.
– Never block the slots and openings by placing
the set on a bed, sofa, rug or other similar
surface.
Power-Cord Protection
– Route the power
cord in order not to be walked on or pinched by
items placed upon or against them, paying
particular attention to the plugs, receptacles, and
the point where the cord exits from the
appliance.
– Do not place the set over a radiator or heat
register, or where it is exposed to direct
sunlight.
In the normal temperature, if you
pour a cold liquid into a glass,
water vapour in the air will
condense on the surface of the
glass.
This is moisture condensation.
The moisture condensation may
occur inside of VCPs, if used in this
condition, it will cause damage to
the head and the tape.
In case of moving the VCP from a
cold place to heated place.
Or the temperature of surroundings
goes up due to room heating
switched on.
Or moving the VCP suddenly from
airconditioned room to a place of
high temperature of humidity in
summer.
When the moisture condensation
occurs inside of the VCP, NEVER
insert the cassette into the cass-
ette compartment.
Remove the cassette, if loaded, by
pressing the STOP/EJECT key.
Only operate the VCP after the
moisture condensation has
completely dried out.
Normally, it takes about 2 hours.
Portable Cart Warning
– An appliance and
cart combination should be moved with care.
Quick stops, excessive force, and uneven
surfaces may cause the appliance and cart
combination to overturn.
– Never place the set in a confined space such as
a bookcase, or built-in cabinet unless proper
ventilation is provided.
