Daewoo Solar 340LC-V, Руководство по ремонту

Страница: 590 / 656

S0802220K
Page 38 Electrical System
NOTE:
1. If a communication error is generated during operation, the power mode, work mode and auto
idle mode will be maintained at the last mode setting before the failure took place until the unit is
shutdown.
2. When start switch is turned to the "ON" position during a period of a communication error, the
e-EPOS controller will operate in the following modes.
• Power mode: Standard mode
11
EPPR v/v open Open Circuit -
Automatic reset
when problem is
corrected
12
Press Up s/v open Open Circuit -
13
Swing pri. s/v open Open Circuit -
21
Dial Voltage Err (H)
Output voltage Over
4.6
±
0.2 V
-
22
Dial Voltage Err (L)
Output voltage Over
0.4
±
0.2 V
-
23
TPS Voltage Err (H)
Output voltage Over
4.6
±
0.2 V
Cut off EPPR v/
v current (0 mA)
24
TPS Voltage Err (L)
Output voltage Over
0.4
±
0.2 V
Cut off EPPR v/
v current (0 mA)
25
Fpump Sensor Err (H)
Output voltage Over
4.6
±
0.2 V
-
26
Fpump Sensor Err (L)
Output voltage Over
0.4
±
0.2 V
-
27
Rpump Sensor Err (H)
Output voltage Over
4.6
±
0.2 V
-
28
Rpump Sensor Err (L)
Output voltage Over
0.4
±
0.2 V
-
29
Speed Sensor Err
Under 1067
±
20Hz (On
condition that alternator
output exceeds over
12
±
1V)
-
31
Fuel shot to GND
Sensor’s resistance
between two terminals is
under 150
±
100
Ω
-
32
Fuel Sensor open
Sensor’s resistance
between two terminals is
under 6.5
±
0.5 k
Ω
-
33
Alternator too high
Output voltage of
alternator exceeds 33 V
for more than 3 seconds -
34
Alternator too low
When the output voltage
is maintained under
18
±
1 for more than 3
seconds (On condition
that speed sensor output
exceeds over 1,067Hz)
-
Code Contents Cause Operation
Reset
Procedure