022-00028AE Operation and Maintenance Manual
Operation 3-1
3
OPERATION
INSTRUMENT PANEL CONTROL FUNCTIONS
MONITORING SYSTEM
Monitoring system uses network circuits between control system and sensors installed at various machine
system locations to monitor selected conditions. This monitoring systems function is to continually inform
operator of machine’s condition. Displays and gauge readouts on instrument panel provide information
such as engine speed, engine coolant temperature, transmission oil pressure, and electrical charge status.
NEW MACHINE BREAK-IN PROCEDURES
All Daewoo wheel loaders are inspected and adjusted before leaving the factory. However, it is required
that the operator follow these steps during initial break-in period. Failure to follow these steps may result in
damage to equipment or reduced performance.
1.
Make sure to check all fluid levels before starting and every 8 to 10 operating hours.
2.
Do all Daily maintenance and service checks.
3.
For first 50 operational hours, as shown by hour meter on control console, do not exceed 80% of
maximum rated engine speed.
4.
At end of first 50 operational hours, drain engine oil. Replace engine oil filter and engine oil.
WARNING!
Before operating any Daewoo wheel loader, read and understand "Operating Controls" section
of this manual.
