2
This appliance must be earthed. In the event
of an electrical short circuit, earthing
reduces the risk of electric shock by
providing an escape wire for the electric
current. This appliance is equipped with a
cord having a earthing wire with a earthing
plug. The plug must be plugged into an
outlet that is properly installed and earthed.
WARNING
Improper use of the earthing plug can result
in a risk of electric shock.
Consult a qualified electrician or serviceman
if the earthing instructions are not
completely understood, or if doubt exists as
to whether the appliance is properly earthed.
If it is neceswsary to use an extension cord,
use only a 3-wire extension cord that has a
3-blade earthing plug, and a 3-slot
receptacle that will accept the plug on the
appliance. The marked rating of the
extension cord should be equal to or greater
than the electrical rating of the appliance.
1. Steady, flat location
This oven should be set on a steady, flat
surface. This oven is designed for counter
top use only.
2. Leave space behind and side
All air vents should be kept a clearance.
If all vents are covered during operation,
the oven may overheat and, eventually,
oven failure.
3. Away from radio and TV sets
Poor television reception and radio interference
may result if the oven is located close to a TV,
Radio antenna, feeder and so on.
Position the oven as far from them as possible.
4. Away from heating appliance and
water taps
Keep the oven away from hot air, steam or
splash when choosing a place to position it,
or the insulation might be adversely
affected and breakdowns occur.
5. Power supply
• Check your local power source. This oven
requires a current of approximately 6
amperes, 220V~ 60Hz. (P TYPE ONLY)
• Power supply cord is about 0.8 meters long.
• The voltage used must be the same as
specified on this oven. Using a higher
voltage may result in a fire or other
accident causing oven damage. Using
low voltage will cause slow cooking.
We are not responsible for damage resulting
from use of this oven with a voltage of
ampere fuse other than those specified.
• If the supply cord is damaged. It must
be replaced by the manufacturer or its
service agent or similarly qualified
person in order to avoid a hazard.
6. Examine the oven after unpacking for
any damage such as:
A misaligned door, Broken door, A dent in
cavity. If any of the above are visible, DO NOT
INSTALL, and notify dealer immediately.
7. Do not operate the oven if it is colder
than room termperature.
(This may occur during delivery in cold
weather.) Allow the oven to become
room temperature before operating.
8. The minimum height of free space
necessary above the top surface of the
oven is 100mm.
EARTHING
INSTRUCTIONS
INSTALLATION
KOR-63DB0P/63FB0P(¿ )
01.10.17
4:43
PM
˘
`
2